Re: How to configurate MCA for Octave

[Hulusi Öz <hulusi.oz1@gmail.com>]

Thanks for your recommendation. I made that. I'm new at either linux or EPICS platform. I'm still learning too much new things.

2016-07-23 2:39 GMT+03:00 Hulusi Öz <hulusi.oz1@gmail.com>:

I just figured it out by adding "savepath" command after each of path command at the previous command. 

But still I'm getting error about mca.mex. I guess ,again, I couldn't build MCA extension in terms of mex file. I run the script (buildForOctave.sh) and after that, I run make. I've got this error :

%-----------%

mex -v -I/opt/epics/base/include -I/opt/epics/base/include/os/Linux -DEPICS_DLL_NO -L/opt/epics/base/lib/linux-x86_64 -ldbStaticHost -lCom -lca mca.cpp MCAError.cpp Channel.cpp -o O.linux-x86_64/mca.mexglx

make: mex: Command not found

Makefile:66: recipe for target 'O.linux-x86_64/mca.mexglx' failed

make: *** [O.linux-x86_64/mca.mexglx] Error 127

%-----------%

Thanks in advance..Best Regards..

2016-07-23 1:29 GMT+03:00 Hulusi Öz <hulusi.oz1@gmail.com>:

Thank you so much sir.. It works fine.

The things that I've done so far since yesterday are :

1) I managed to build MCA extension for Octave properly.

2) Now,I can run the examples.

3) But, I think ,I miss something about editing path for octave for mcaget,mcaput.. commands,because Octave doesn't see those commands. But I had done it by doing that in Octave : 

path(path(), [getenv("opt") "/opt/epics/extensions/lib/" getenv("linux-x86_64")]); path(path(), [getenv("opt") "/opt/extensions/src/mca/matlab"]);

2016-07-23 1:06 GMT+03:00 Eric Norum <eric@norum.ca>:

Once you have your PATH set properly you should need to type only

makeBaseApp.pl …….

since that script is in the EPICS base bin.

On Jul 22, 2016, at 3:01 PM, Hulusi Öz <hulusi.oz1@gmail.com> wrote:

1) I make an IOC example with 

                 "../../../makeBaseApp -t example example"

                 "../../../makeBaseApp -i -t example example"

I've got the same result as the same with Eric Norum's.

-- 
Eric Norum
eric@norum.ca