Experimental Physics and
Industrial Control System

"Sintschuk, Michael via Tech-talk" <[email protected]> · Fri, 20 Sep 2019 07:32:45 +0000

Hi Kevin,

thanks for the help! The old driver is working fine for me, so I stay with it for now.
However if there will be a E-816 compatible EPICS PIGCS2 driver in future, I would change to it.

Michael 

-----Ursprüngliche Nachricht-----
Von: Peterson, Kevin M. <[email protected]> 
Gesendet: Donnerstag, 19. September 2019 17:08
An: Rivers, Mark L. <[email protected]>; Torsten Bögershausen <[email protected]>; Sintschuk, Michael <[email protected]>
Cc: tech-talk <[email protected]>
Betreff: Re: AW: Correct Settings for PIE816 Controller

I created a github issue for this:

   https://github.com/epics-motor/motorPIGCS2/issues/3

I'm currently unable to email Steffen Rau for cybersecurity reasons that I don't understand.  He has told me in the past that he isn't able to access github due to proxy issues.  Given these communication difficulties, I would recommend using the old, non-PIGCS2 driver for now.

Kevin

On 9/19/19 6:46 AM, Mark Rivers wrote:
> Hi Michael,
> 
> I think that a derived class for the E-816 would need to be written.  You could contact PI (Steffen Rau?) about that.  It looks like the motorPIGCS2 module should support both GCS and GCS2 devices.  Yours does not appear to be GCS2 because it does not list support for the CSV? command.
> 
> Mark

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System